Increase Wall Loops bad outer wall - Bambu Lab Community Forum I only changed the Wall Loops from 2 to 6 in the Standard profile and again bad outer walls This is what I tried so far (every time bad result): Selecting the Standard profile and changed the Wall Loops to 6; Using different infill patterns; Changed outer wall speed to 60mm s; Changed the Order of inner outer wall (all of them)
TPU 3D Printing: A Guide to 3D Printing Flexible Parts - AMFG 1 5 mm is the minimum wall thickness when using TPU powder Parts 3D printed with 1 5 mm walls will be very flexible but you can also make your part more rigid by increasing the wall thickness to 3 mm
Tire printing - 3D Printing - Maker Forums I’m trying to print the small tire (goes on a luggage wheel) in TPU, but don’t seem to have the proper setting in CURA It’s being printed as printed as shown in the picture and I’ve used LINES for support
How to add more walls? - Bambu Lab Community Forum By default, Bambu Studio only prints one top wall (for neatness), but the rest should be as defined by “Wall Loops” You can change this if you wish further down the Strength panel @ Advanced => “Only one wall on top surfaces”
Wall loops vs Inner Fills : r BambuLab - Reddit I'm printing square tubular parts 4in x 4iin x 4mm wall thickness, using 5 Wall loops and not using any Inner fills It is my understanding Wall loops would be stronger then using 1 or 2 Wall loops with some infill
Detailed information about the meaning of settings Wall loops is the number of outer wall-lines you get at your print More wall would increase the strenght If you will check this, take a model an slice it, then make a cut in a middle layer an watch at the line-type
How do you decide how many walls to print? : r 3Dprinting - Reddit These are basically the only things I'll consider; 1-4 perimeters unless the designer recommended otherwise Too many walls will just increase the print time, nothing detrimental Walls > infill I'll have a look at mine I'm sure it's set to 7
IMPORTANT: min. 6 Wall loops - Simplify3D When someone says "wall loops", I would have assumed they were talking about the number of perimeter outlines That determines how many rings are created around the outside of the part